Table of Contents
Advertisement
Menu Number
/ Short Name
Voice Prompt
Allows audible voice confirmation of a key press
14
Settings: OFF[0] | ENG[1] | CHI[2]
VOICE
Note:
Automatic Number Identification
15
Displays the ANI code that has been set by software. This menu can not be used to
ANI-ID
change it. The ANI-ID is sent when the alarm is activated and menu 32 = CODE
DTMF Side Tones
Determines when DTMF Side Tones can be heard from the transceiver speaker.
Settings: OFF[0] | DT-ST[1] | ANI-ST[2] | DT+ANI[3]
OFF: No DTMF Side Tones are heard
DT-ST: Side Tones are heard only from manually keyed DTMF codes
16
ANI-ST: Side Tones are heard only from automatically keyed DTMF codes
DTMFST
DT+ANI: All DTMF Side Tones are heard
Note: Requires the transceiver to be in transmit mode.
Note: Recommended setting is DT+ANI
Note: [MENU]=A, [▲]=B, [▼]=C, [EXIT/AB]=D (†)
PTT-ID DTMF Code Selection
Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up
17
to 5 digits each.
S-CODE
Settings:
Note: Menu 19 must be enabled for an S-CODE to be transmitted.
Scanning Resume Method
Settings: TO[0] | CO[1] | SE[2]
18
TO: Time Operation - scanning will resume after a fixed time has passed
SC-REV
CO:
SE: Search Operation - scanning will not resume
When to Send PTT-ID
Settings: OFF[0] | BOT[1] | EOT[2] | BOTH[3]
OFF: No ID is sent
19
BOT: The selected S-CODE is sent at the Beginning of Transmission
PTT-ID
EOT: The selected S-CODE is sent at the End of Transmission
BOTH: The selected S-CODE is sent at the BOT and the EOT
Note: Select S-CODE using menu 17
Note: Recommended setting is OFF
PTT-ID Delay (milliseconds)
20
Settings: 0 - 50
PTT-LT
Note: Requires menu 19 to be enabled
Reference for UV-82 Menus
by Jim Unroe - KC9HI
(send comments, suggestions or corrections to UV-82@KC9HI.net)
Long Name / Description / Settings / Notes
Not all voice prompts are easily understandable. Not all key presses
have a voice prompt.
(†) The Side Tone heard for 'D' is '0' (zero) but 'D' is sent over-the-air
1[0] | 2[1] | 3[2] | 4[3] | 5[4] | 6[5] | 7[6] | 8[9] | 9[8]
| 10[9] | 11[10] | 12[11] | 13[12] | 14[13] | 15[14]
Carrier Operation - scanning will resume after the active signal
disappears
11-January-2014
Default: CHI
Default: DT+ANI
Default: 1
Default: TO
Default: OFF
Default: 5
Separate
MR/
VFO/
Channel
Frequency
Global
Mode
Mode
✓
RO
✓
RO
✓
✓
RO
✓
✓
Stored
VFO
on a Per
A & B
Channel
Settings
Basis
✓
✓
✓
Hide quick links:
Advertisement
Table of Contents
