Baofeng UV-82 User Manual page 71

Menu Number
/ Short Name
[A] MR/Channel Mode Display Format
Settings: CH[0] | NAME[1] | FREQ[2]
CH: Displays the channel number
21
MDF-A
NAME:
FREQ: Displays programmed Frequency
[B] MR/Channel Mode Display Format
Settings: CH[0] | NAME[1] | FREQ[2]
CH: Displays the channel number
22
MDF-B
NAME:
FREQ: Displays programmed Frequency
Busy Channel Lock-Out
Disables the [PTT] button on a channel that is already in use. The transceiver will sound a
23
beep tone and will not transmit if the [PTT] button is pressed when a channel is already in
BCL
use.
Settings: OFF[0] | ON[1]
Automatic Keypad Lock
When ON, the keypad will be locked if not used in 8 secs. Pressing the [#╓O] key for 2
seconds will unlock the keypad.
24
Settings: OFF[0] | ON[1]
AUTOLK
Note: When the keypad is locked, a '╓O' is indicated in the status display
Note:
Direction of Frequency Shift
Enables access of repeaters in VFO/Frequency Mode
Settings: OFF[0] | +[1] | -[2]
OFF: TX = RX (simplex)
25
Note:
SFT-D
Note:
Note:
Note:
Frequency Shift (MHz)
Specifies the difference between the TX and RX frequencies
Settings: 00.000 - 69.990 in 10 kHz steps
26
Note: Used with menu 25 to access repeaters in VFO/Frequency mode
OFFSET
Note: Typical ham offsets are: VHF = 00.600 UHF = 05.000
Note:
Reference for UV-82 Menus
by Jim Unroe - KC9HI
(send comments, suggestions or corrections to UV-82@KC9HI.net)
Long Name / Description / Settings / Notes
Displays the channel name. Names must be entered using software.
A channel without an assigned name with have the channel number
displayed
Displays the channel name. Names must be entered using software.
A channel without an assigned name with have the channel number
displayed
The keypad lock only locks the buttons on the front face of the UV-
82. It does not lock the [CALL] button, the [PTT] button or the [MONI]
button.
+: TX will be shifted higher in frequency than RX
-: TX will be shifted lower in frequency than RX
When SFT-D is set to +, a '+' is indicated in the status display
(VFO/Frequency mode only)
When SFT-D is set to -, a '-' is indicated in the status display
(VFO/Frequency mode only)
Used with menu 26 to access repeaters in VFO/Frequency mode (+
and - only)
SFT-D is not required when storing repeater frequencies into
channels
OFFSET is not required when storing repeater frequencies into
channels
11-January-2014
Default: NAME
Default: FREQ
Default: OFF
Default: OFF
Default: OFF
Default: 00.600
Separate
MR/ VFO/
Channel Frequency
Global Mode Mode
✓
✓
RO ✓
✓
⦸ ✓
⦸ ✓
Stored
VFO on a Per
A & B Channel
Settings Basis
✓
✓
✓