Baofeng UV-82 User Manual page 67

Column Values Description/Comment
Used for setting squelch using carrier squelch and/or CTCSS (aka PL) and/or DTS (aka DPL). Only
Cross Mode
used when enabled by other options
Tone->Tone The radio will use CTCSS for transmit and a different CTCSS for receive
Tone->DTCS The radio will use CTCSS for transmit and DCS for receive
DTCS->Tone The radio will use DCS for transmit and CTCSS for receive
->Tone The radio will not transmit CTCSS or DCS but will enable CTCSS for receive
->DTCS The radio will not transmit CTCSS or DCS but will enable DCS for receive
DTCS-> The radio will use DCS for transmit. In this mode, the receiver is carrier squelch
DTCS->DTCS The radio will use DCS for transmit and a different DCS for receive
Duplex Used for determining the transmit (TX) frequency
(none) Simplex. Sets the transmit frequency to the same value as the receive frequency (aka simplex)
- Sets the transmit frequency lower than the receive frequency by the Offset amount (aka - duplex)
+ Sets the transmit frequency higher than the receive frequency by the Offset amount (aka + duplex)
split Sets the transmit frequency to the value in Offset (same value range as the receive frequency)
off Receive only (transmit inhibited).
Used for setting the transmit frequency difference (offset) from the receive frequency. When Duplex
Offset
is set to 'split' this value is the actual transmit frequency
Mode Sets the transmitter deviation and receiver IF bandwidth
FM 5KHz deviation (for Part 97 - Amateur Radio Service)
NFM 2.5KHz deviation (for Part 90 - Private Land Mobile Radio Services)
Power Sets the transmit output power level
High 4 watts
Low 1 watt
Skip Sets the channel scan lockout
Scan channel in scanning mode
S Skip (lockout) channel in scanning mode
CHIRP Programming Reference
Jim Unroe - KC9HI
14-January-2013
(send comments, suggestions or corrections to UV-5R@KC9HI.net)
Requires
Tone Mode=Cross
Tone (TX) and ToneSql (RX)
Tone (TX), DTCS Rx Code (RX) and DTCS Pol
DTCS Code (TX), DTCS Pol and ToneSql (RX)
ToneSql (RX)
DTCS Rx Code (RX) and DTCS Pol
DTCS Code (TX) and DTCS Pol
DTCS Code (TX), DTCS Rx Code (RX) and DTCS Pol
Offset
Offset
Offset (entered as transmit frequency)