Flashing The Hood Pin Switch - Autostart as2520 Installation Manual

2-Pin Harness
Wire Colour Function
BLUE/
1 (–) N/A
WHITE
(–) Parking
2 YELLOW
Light output

Flashing the Hood Pin Switch

Flashing the hood pin switch is a procedure that brings the module into programming mode. Once
the module is in programming mode, the installer will have up to 20 seconds to select one of the
sub-menus. If the installer fails to select a sub-menu before the 20-second delay, the module will
exit programming mode and the installer will have to flash the hood pin switch once more.
Tip As long as the hood is up, you may use the programming assistance button instead of the
hood pin switch.
Here are the steps which the installer must follow in order to flash the hood pin switch:
The Installer ...
1. Press and hold the hood pin switch for 4 seconds.
2. Release the hood pin switch.
3. While the parking lights are
pin switch once more.
4. Release the hood
Caution! If you press down and release the hood pin
switch too many times, you will enter diagnostic
mode rather than programming mode.
5. You now have 20 seconds to select one of the sub-
menus.
Once the module has entered programming mode, you will have a selection of many different sub-
menus, which will be described later in this guide:
a. Transmitter Programming .............................................. p.10
b. Horn Timing (if available)............................................... p.14
c. Tach Programming ........................................................ p.13
Note: Once the parking lights are ON (solid), you have up to 20 seconds to select a sub-menu. If
you do not select a sub-menu within 20 seconds, the module will exit programming mode and you
will have to flash the hood pin switch once again.
Installation Guide
Description
This pin is not used. Leave it empty.
500 mA negative parking light output
Note: Ensure that the voltage does not vary when the
dimmer control switch is turned up or down. If this is the
case, it is not the right wire.
There is a also a positive parking light output. Only one of
these two different outputs needs to be connected.
The parking lights will turn
, press down the hood
ON
pin switch again. The parking lights will stay
Flashing the Hood Pin switch
The Module ...
.
ON
ON
for 20 seconds
P. 9