Diagnostics - Parking Light Flash Table - Autostart as2520 Installation Manual

Diagnostics – Parking Light Flash Table
Flashes
Doors locked, starter kill armed.
End of run time.
button pressed
TRUNK
1
Start signal received by the module.
Cold weather mode cancelled.
Cannot start after maximum number of attempts is reached.
Doors unlocked, starter kill disarmed.
Run time cancelled.
2 Remote start attempt cancelled by remote.
Exiting remote valet
Exiting ignition valet
Entering cold weather mode.
Entering extended run time.
3
Entering remote valet
Entering ignition valet
+12 V where detected on the brake line and cranking was cancelled.
4
Entering tach-programming mode
New transmitter programmed.
5
Tach programmed.
A remote start was attempted while a tach or a vacuum signal was detected
6
before cranking.
Unit reset: occurs when the unit is reset to the factory defaults.
8
10 The hood switch line went to ground during cranking or run time.
1 – pause – 2 There was an attempt to start the vehicle while the module was in valet
mode.
Cold weather mode: the brake pedal is being held down.
ON solid
There was an attempt to start the vehicle while the module was in home valet
2 – pause – 2
mode.
The hood is up and the hood switch line went to ground. This is step one of
ON 2 sec.
the programming centre procedure.
ON 3 sec. First press of the
ON 4 sec. Locking or unlocking a door (with door pulses configured to 4 sec.)
The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for
20 seconds.
ON 25 sec.
Or the unit went into step 1 of the transmitter programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.
If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back start failure codes.
Irregular
This occurs when the hood pin-switch is pressed three times
Constant
Panic mode is triggered.
flashes
up to 30 sec.
Installation Guide
Description
button under safe start.
START
P. 19