The Programming Assistance Button; Programming The Transmitter; Before You Proceed; The Transmitter Programming Procedure - Autostart as2520 Installation Manual

The Programming Assistance Button

Caution: The hood pin switch must be installed and connected in order for the programming
assistance button to function. The button will work only when the hood is up.

Programming the Transmitter

Before you proceed

The transmitter of the module is not delivered pre-programmed: it must be programmed after the
wiring of the module is completed. The module has the ability to retain up to 4 different transmitter
codes; if a fifth transmitter is programmed, the code of the first transmitter will be lost from memory.
To erase all transmitter codes from memory, you must perform a reset of the module (see
Resetting the Module on page 17, for more details).

The Transmitter Programming Procedure

1. Flash the hood pin switch (see page 9)
– The parking lights will stay
– Before the lights go out, turn the ignition key to the
– Immediately turn the ignition key back to the
2. Press and hold the
– The module has stored the code of the transmitter into memory.
3. To exit: close the hood.
To program a transmitter on the second vehicle for multi-car operation, you must press the
button (instead of or
LOCK UNLOCK

Entering Programming Options Mode

The module is equipped with four custom programming modes that allow the installer to custom-fit
the system outputs according to installation requirements. The programming options are designed
to facilitate interfacing with all vehicle types. To enter the programming center, follow either
procedure (Table 1 or Table 2); please note that the second procedure requires the use of the
plug-in valet:
P. 10
(A.k.a. the PAB.) Mounted on the module, this
button can be used from within the vehicle instead of
the hood pin switch in the engine compartment. This
will spare the installer the trouble of accessing the
hood pin switch in the engine compartment.
for up to 20 seconds.
ON
OFF
button until the parking lights flash 5 times quickly.
LOCK
Programming a Transmitter
) in step 2 of the transmitter programming procedure:
position.
IGNITION ON (RUN)
position.
TRUNK
Installation Guide