Autostart as2520 Installation Manual page 7

(–) External
9 PURPLE
Trigger
(–) Ground
Out
10 WHITE
When
Running
11 GREY (–) N/A
Installation Guide
The external trigger wire can be used for remote-starting the
vehicle with an external device. When the vehicle is running,
triggering this input will activate idle mode. The external trigger
wire can also be used to operate as a negative trigger with the
trunk pin-switch, the key sense wire or the door pin-switch:
Option 1 Connects to negative trunk pin. When this wire is
programmed for trunk pin, pressing
second disarm output. If ground (-) is detected on the
pin (the trunk has been opened), an arm pulse will be sent 5
seconds after the trunk is closes. An arm pulse will be sent 4
seconds after the button is pressed if the trunk pin state
TRUNK
is unchanged (The trunk was unopened). Disarm is sent only if
the system was previously locked and armed. If secure lock is
enabled, unlock pulse(s) will be sent with disarm, a
and a rearm pulse will be sent when the Trunk is closed or if
the Trunk was left closed.
Option 2 (Default: engine start/stop): The first ground (-) pulse
on this input will start the engine, the second ground (-) pulse
on this input will stop the engine.
Option 3 (Key Sense (-) Input): Connects to OEM key sense
wire. When the key is detected in the ignition switch (ground (-)
signal on the OEM key sense wire) the starter kill will not arm
even when it is set to passive mode. If secure lock is
programmed, lock and arm will not be activated while the key
sense input is active ("active" meaning there is a key in the
ignition barrel).
Option 4 (Smart ignition re-lock): Connects to the negative
door trigger input. When the ignition lock option or the lock only
option is enabled, after the brake pedal is pressed and after a
door has been opened and closed, the doors will
This wire provides a constant 500 mA ground output while the
module is running. This output becomes active at the same
time as the ignition and shuts off when the module shuts down,
e.g.: when the run time has expired, when the
button has been pressed, etc. This output can be used to
activate external relays, bypass kits, etc.
Caution! If multiple relays or modules are connected to the
ground- out-when-running wire, make sure they are diode
isolated from one another: feedback may otherwise occur,
causing damage to the vehicle.
This pin is not used. Leave it empty.
will activate a 1-
TRUNK
TRUNK
pulse
LOCK
.
RE-LOCK
START/STOP
P. 7