Input/Output Assign - Integra DTR-60.5 Instruction Manual

Explanatory Notes
2. Speaker Setup
Speaker Configuration
■
Subwoofer
Yes
No
Main Menu
Sub Menu
Setting target
Setting options (default setting underlined)
Sub Menu
Main Menu

1. Input/Output Assign

Monitor Out
On the "Monitor Out" settings, you can select
whether or not to have the video sources' images
output through the HDMI/HDBaseT™ output.
If you connect your TV to HDMI/HDBaseT output,
"Monitor Out" setting is automatically set and
composite video and component video sources are
upconverted * and output.
Composite video,
component video
IN
OUT
Composite video, HDMI/HDBaseT
component video
Note
• See "The video and audio signal flow" (➔ page 19) for
charts showing how the "Monitor Out" and "Resolution"
settings affect the video signal flow through the AV
receiver.
■
Monitor Out
HDMI:
Select this if your TV is connected to HDMI OUT.
HDBaseT(TM):
Select this if your TV is connected to
HDBaseT(TM).
Both:
Select this if your TVs are connected to HDMI
OUT and HDBaseT(TM). Video signals are
output from both HDMI and HDBaseT outputs at
the resolution supported by both TVs.
En-60
Note
• The "HDMI Through" setting is only available for the HDMI
OUT jack (➔ page 78).
Operating on the AV receiver
1 Press Monitor Out on the front panel.
The current setting is displayed.
2 Press Monitor Out on the AV receiver
HDMI
repeatedly to select:
HDMI, HDBaseT or Both.
■
Zone 2 Monitor Out
Not Use
HDBaseT(TM)
When this setting is enabled, the TV connected to
HDBaseT(TM) can be used as the TV of Zone 2.
Tip
• On the connected component, select the mode in which the
delay between the video and audio does not occur much if
the video signal delay occurs during the playback on the
video component connected to the AV receiver.
Note
• This setting cannot be selected if the "Monitor Out" setting
is set to "HDBaseT(TM)" or "Both".
• When this setting is set to "HDBaseT(TM)", the "11ch
Playback" setting is fixed to "No" (➔ page 63).
• When this setting is set to "HDBaseT(TM)" and "GAME2" is
selected as the input source for Zone 2, if this setting is
changed to "Not Use", the input source for Zone 2 will be
changed to "Zone 2 Selector: Source" (➔ page 83).
Advanced Operations
Operating procedure (➔ page 59)