EFX576i Elliptical Fitness Crosstrainer Assembly Guide
Rear
view of
console
ttach the upright supports to the base frame using eight
A
buttonhead screws (A), eight split washers (D), and eight
washers (B). Finger tighten.
Ask your assistant to hold the display console above the
upright supports while you connect the cable. Remove and
discard the tape after you connect the cable.
Important: Place excess cable inside the upright support.
ave your assistant lower the display console while you align
H
the mounting brackets on the inside of the upright supports.
F
asten the display console to each upright support by
threading a buttonhead screw (A) and washer (B) through
opposite mounting holes. Check that the base fasteners are
loose before installing the display console fasteners.
CAUTION: Make sure the display console screws are
properly threaded into the inserts. Do not cross thread.
The Precor Limited Warranty does not cover damage that
occurs during installation.
C
heck alignments and thread the remaining four display
console screws (A) and four washers (B). Wrench tighten with
a ³⁄₁₆-inch hex key so the assemblies come together, but leave
room for adjustments.
hen all fasteners are snug against the unit, begin at the base
W
and alternately wrench tighten all fasteners. Follow the
sequence from step 3 through step 7.
5