Precor C956i Product Owners Manual page 16

Table 2. Club custom features and settings
Unit Club Programming Prompt
Treadmill SAFETY CODE
All * SELECT LANGUAGE
All * SELECT UNITS
All * SET MAX WORKOUT TIME
All * SET MAX PAUSE TIME
All * SET COOL DOWN TIME
Treadmill SET SPEED LIMIT
Treadmill SET INCLINE LIMIT
Treadmill HIDDEN PROGRAMS
Treadmill REMOTE CONTROL
EFX SET CROSSRAMP AUTO-LEVEL
Cycle SET RESISTANCE RANGE
All * SET CUSTOM PROGRAM 1
Treadmill SET CUSTOM PROGRAM 2
✱ This feature is available in all Precor club units.
Note: When you make changes in club programming mode, the new settings replace the factory defaults. If a user changes the language or unit of measure during an exercise
session, the display resets to the new club settings when a user's workout ends.
Product Owner's Manual: Club Features
Factory Default Setting
Disabled
English
U.S.
60 minutes
120 seconds
5 minutes
Maximum speed available.
Maximum grade possible.
Hide programs
Disabled
Mid-level of ramp incline range
High
Random profile
Random profile
Changes you can make
An enabled safety code requires a 4-digit entry code before users can access
any exercise programs.
Seven languages affect the display prompts. Choose one.
Two standard units of measure affect the display prompts. Choose between U.S.
or Metric.
Exercise session time limits range from 1 to 240 minutes. NO LIMIT is accessible
beyond 240 minutes.
Pause time limits range from 1 to 120 seconds (2 minutes). Restrictions exist for
self-powered units.
Cool down time limits range from 1 to 5 minutes.
Refer to Treadmill: Determining the Club Speed Limit.
Refer to Treadmill: Setting an Incline Limit.
Two options are available: Show Programs or Hide Programs. Choose one.
A computer must be connected through the CSAFE port to enable this feature
and change the speed or incline for a specific user.
This prompt only appears on EFX units which have adjustable ramps. Settings
range from 1 to 20. Refer to EFX: Changing the Auto-Level Setting.
Settings range from High, Medium, and Low. Refer to Cycle: Setting a
Resistance Range.
Modify the program profile. Refer to Creating a Custom Program.
Modify the program profile. Refer to Creating a Custom Program.
14