Removing Flywheel Using Puller; Remove The Stator; Remove Valve Cover And Cylinder Head; Valve Cover And Gasket Details - Kohler Courage SV470-600 Service Manual

Figure 8-24. Removing Flywheel Using Puller.
5. Remove the flywheel key from the crankshaft.

Remove the Stator

1. Remove the two screws securing the stator to the
closure plate bosses. See Figure 8-25.
NOTE: To disconnect the B+ or stator leads from the
wiring harness connector, insert a small
screwdriver, or similar narrow flat blade, and
bend down the locking tang of the
terminal(s). Gently pull the lead(s) out of the
connector.
Figure 8-25. Removing Stator.

Remove Valve Cover and Cylinder Head

1. Remove the seven screws securing the valve
cover and any attached brackets. See Figure
8-26.
www.SmallEngineDiscount.com
Figure 8-26. Removing Valve Cover Screws.
2. Remove the valve cover and gasket from the
cylinder head. See Figure 8-27.
Figure 8-27. Valve Cover and Gasket Details.
3. Loosen the inner set screws (T15 TORX) and
back off the rocker arm adjusting nuts. Remove
the push rods and mark them, so they can be
reinstalled in the same location. See Figure 8-28.
Figure 8-28. Loosening Adjustment Set Screw and
Nut.
Not For Resale
Section 8
Disassembly
8
8.7