Removing Fan And Flywheel Mounting Hardware; Removing Flywheel Using Puller; Remove The Stator; Remove The Valve Cover And Cylinder Head - Kohler Courage SV470 Service Manual

Figure 8-24. Removing Fan and Flywheel Mounting
Hardware.
3. Carefully lift the cooling fan to disengage the two
drive pins and remove it from the flywheel.
4. Remove the flywheel from the crankshaft using a
puller. See Figure 8-25.
NOTE: Always use a puller to remove the
flywheel from the crankshaft. Do not
strike the crankshaft or flywheel, as they
could be cracked or damaged.
Figure 8-25. Removing Flywheel Using Puller.
5. Remove the flywheel key from the crank shaft.

Remove the Stator

1. Remove the two screws securing the stator to the
closure plate bosses. See Figure 8-26.
NOTE: To disconnect the B+ or stator leads from
the wiring harness connector, insert a
small screwdriver, or similar narrow flat
blade, and bend down the locking tang
of the terminal(s). Gently pull the lead(s)
out of the connector.
Figure 8-26. Removing Stator.

Remove the Valve Cover and Cylinder Head

1. Remove the seven screws securing the valve cover
and any attached brackets. See Figure 8-27.
Figure 8-27. Removing Valve Cover Screws.
2. Remove the valve cover and gasket from the
cylinder head. See Figure 8-28.
Figure 8-28. Valve Cover and Gasket Details.
Section 8
Disassembly
8
8.7