Real Time Clock - Toshiba NB10 User Manual

Problem
Battery doesn't
charge when the AC
adaptor is attached.
Battery doesn't
power the computer
as long as expected

Real Time Clock

Problem
The BIOS setting
and system date/
time are lost.
Keyboard
Keyboard problems can be caused by the setup and configuration of the
computer - please refer to the
User's Manual
Procedure
If the battery is completely discharged, it will not
begin charging immediately, in these instances you
should wait a few minutes before trying again. If
the battery still does not charge, you should check
that the power outlet the AC adaptor is connected
to its supplying power - this can be tested by
plugging another appliance into it.
Check whether the battery is hot or cold to the
touch - if so, it will not charge properly and should
be allowed to reach room temperature before you
try again.
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential - in these instances you should fully
discharge the battery and then attempt to charge it
again.
Check the Power saver option under Select a
power plan in the Power Options.
Procedure
The charge in the Real Time Clock (RTC) battery
has run out - you will need to set the date and time
in the BIOS setup application by using the
following steps:
1. In the Settings charm, click Power and then
select Restart.
2. Hold down the F2 key and then release this
key one second after the computer is power
on - the BIOS setup utility will load.
3. Set the date in the System Date field.
4. Set the time in the System Time field.
5. Press F10 - a confirmation message will be
displayed.
6. Select Yes - the BIOS setup application will
end and the computer will restart.
The Keyboard section for further information.
6-6