Section 8-Seat And Back; Replacing The Seat Upholstery - Invacare P9000 XDT Owner's Operator And Maintenance Manual

SECTION 8—SEAT AND BACK
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that on/off switch
on the joystick is in the off position.

Replacing the Seat Upholstery

NOTE: For the following procedure, refer to FIGURE 8.1.
1. Remove the mounting screws that secure the existing seat upholstery to the
wheelchair frame.
NOTE: Refer to the following table to determine the number of mounting screws for each seat
depth.
SEAT DEPTH
16 inch
18 inch
2. Remove the existing seat upholstery from the wheelchair frame.
3. Install new seat upholstery by reversing Steps 1-2.
Part No. 1118386
WARNING
NUMBER OF SCREWS
8
10
Mounting Screws
FIGURE 8.1 Replacing the Seat Upholstery
SECTION 8—SEAT AND BACK
39
16-inch Seat Depth
Seat Upholstery
Wheelchair Frame
™
P9000 XDT