Swing-Back Arms; Replacing Armrest Pad - Invacare P9000 XDT Owner's Operator And Maintenance Manual

SECTION 7—ARMS

Swing-Back Arms

Make sure the armrest release lever is in the locked position before using the wheel-
chair.
NOTE: For this procedure, refer to FIGURE 7.2.
1. Unlock the swing-back arms by rotating the armrest release lever towards the outside
of the wheelchair.
2. Pull the front of the swing-back arm straight up/out of the arm socket and towards the
rear of the wheelchair.
3. To use the swing-back arm, push the swing-back arm towards the front of the
wheelchair and then downward into the arm socket.
NOTE: Armrest release lever MUST be in the unlocked position when placing armrest into the
arm sockets.
4. Lock the swing-back arms by rotating the armrest release lever towards the inside of
the wheelchair.
Swing Back Arm
Rear

Replacing Armrest Pad

NOTE: For this procedure, refer to FIGURE 7.3
1. Remove the mounting screws that
secure the armrest pad to the armrest
assembly.
2. Replace armrest pad and securely
tighten with the existing mounting
screws.
™
P9000 XDT
WARNING
FIGURE 7.2 Swing-Back Arms
38
Front
Armrest Release Lever
Arm Socket
Mounting
Screws
FIGURE 7.3 Replacing Armrest Pad
Armrest Pad
Armrest Assembly
Part No. 1118386