Toshiba RAV-SM563UT-E Service Manual page 147

No. Part name
ˆ
Compressor 1) Perform works of items
2) Evacuate refrigerant gas.
3) Disconnect the connector for fan motor from
4) Take off screws fixing the motor base to the
5) Remove the motor base together with the
6) Take off screws fixing the partition plate to
7) Remove the valve support plate.
8) Take off screws of the partition plate and the
9) Take off screws of the partition plate and the
10) Remove the noise-insulator.
11) Remove the terminal covers of the com-
12) Remove pipes connected to the compres-
Pay attention to that flame does not involve
4-way valve or PMV.
(If doing so, a malfunction may be caused.)
13) Pull the refrigerating cycle upward.
14) Take off nut fixing the compressor on the
15) Pull the compressor toward you.
When reconnecting the lead wires to the
compressor terminals after replacement of
the compressor, be sure to caulk the Faston
terminal without loosening.
Procedure
the inverter.
bottom plate. (ST1T Ø4 × 10L, 2 pcs.)
fan motor and the propeller fan.
the valve support plate.
(ST1T Ø4 × 10L, 2 pcs.)
(M6 × 4 pcs.)
bottom plate. (ST1T Ø4 × 10L, 2 pcs.)
heat exchanger. (ST1T Ø4 × 10L, 2 pcs.)
pressor, and disconnect lead wires of the
compressor and the compressor thermo
assembly from the terminal.
sor with a burner.
CAUTION
bottom plate. (3 pcs.)
CAUTION
 ‚ ƒ „
, , , and .
– 147 –
Remarks
Partition plate
Valve support
Screw
Partition
plate
Remove
(Suction
pipe)
Motor
base
Valve
support
Compressor
lead wire
Case thermo
Remove
(Discharge
pipe)
Compressor
nut (3 pcs.)