Heat & Glo ST-HVBI-AU Installation And Operation Instructions Manual page 16

B. Installing Flue Components
After determining which direction the 45º elbow will be
used follow fl ueing instructions accordingly.
• This heater requires the attachment of supplied 45º
elbow to unit before connection of fl ue components.
• To attach the elbow fl ue, the elbow cover plate must
fi rst be removed from the unit (see Figure 16).
• The elbow can be removed from the unit by aligning
the seams of the elbow to the arrows on the
surrounding heat shield (see Figure 17).
• Position the elbow in the horizontal or the vertical
position. Snap in place with the starting collar.
• Replace the elbow cover plate aligning it with the
elbow and secure in place with the 8 screws.
• Place the rope ring around the fi rst section of pipe
and slide it up against the cover plate.
NOTE: The rope ring is needed for the heat manage-
ment and to prevent cold air infi ltration.
ELBOW COVER PLATE
Figure 16
Heat & Glo • ST-HVBI-AU • 2082-900 Rev. J • 10/10
HEAT
ARROWS
SHIELD
FRONT VIEW
Figure 17
Figure 18
WARNING
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least 1-1/2
inches (38 mm).
• Use pilot holes for screws.
• Screws must not exceed one inch
long.
• Pipe may separate if not properly
joined.
ELBOW
SEAM
ELBOW
TOP VIEW
16