Continuous Pilot - Not Used For This Fireplace; Normal Operating Sounds; Normal Operating Odors; Power Outages - Travis Industries Xtreme 6020 Owner's Manual

12
Continuous Pilot – NOT USED FOR THIS FIREPLACE
THIS FIREPLACE SHOULD NOT BE RUN IN CONTINUOUS PILOT. THIS MAY LEAD TO
PREMATURE BLOWER FAILURE AND/OR COLD AIR INFILTRATION INTO THE FIREPLACE. IF
"CONTINUOUS PILOT" APPEARS ON THE LCD SCREEN, FOLLOW THE DIRECTIONS BELOW TO
TURN OFF THIS FEATURE.
Turning Off Continuous Pilot
Press and hold down the "Set" and "Down" arrow buttons. "Continuous Pilot" will no longer appear on the
LCD screen, indicating the fireplace is no longer configured for continuous pilot.

Normal Operating Sounds

This fireplace uses an exhaust blower to pull exhaust gases out of the fireplace. While the fireplace is on
you may hear a slight hum.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas
may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if
the appliance was left idle for a long period.

Power Outages

This fireplace utilizes household power (110 VAC) to power the exhaust blower. It does not operate if
power has been shut off. If power goes out while fireplace is on, the burners will turn off and the fireplace
will remain off until power is restored.

Child Protection Feature

The remote can be disabled to prevent children from operating the fireplace. This is done by holding
down the "Fn" and "Up" button for 5 seconds until "CP" (Child Protection) appears on the screen in the
"ROOM" temperature box. If any button is pressed on the remote "CP" will appear on the screen
indicating the child protection feature is on. To turn this feature off, hold down the "Fn" and "Down" button
for 5 seconds until "CP" (Child Protection) disappears on the screen in the "ROOM" temperature box
© Travis Industries
Operation
4100329
100-01247_000