Usb Interface - Samsung SCX-5315F Service Manual

3-4-2 USB INTERFACE

RD
CS
Endpoint/Contol FIFOs
Control
SIE
Media Access Controller[MAC]
Physical Layer interface[PHY]
Trans ceiver
D+
3-4-2-1 Features
• Full-Speed USB Node Device
• USB transceiver
• 3.3V signal voltage regulator
• 48 MHz oscillator circuit
• Programmable clock generator
• Serial Interface Engine consisting of Physical Layer In-terface (PHY) and Media
• Access Controller (MAC), USB Specification 1.0 compliant
• Control/Status Register File
• USB Function Controller with seven FIFO-based End-points :
• One bidirectional Control Endpoint 0 (8bytes)
- Three Transmit Endpoints (2*32 and 1*64 bytes)
• Three Receive Endpoints (2*32 and 1*64 bytes)
• 8-bit parallel interface with two selectable modes :
- non-multoplexed
• multiplexed (Intel compatible)
• DMA support for parallel interface
• MICROWIRE/PLUS
• 28-pin SO package
Samsung Electronics
VVR D[7:0]/AD[7:0]
A0/ALE
Microcontroller Interface
D-
Upstream Port
Interface
- This Document can not be used without Samsung's authorization -
MODE[1:0]
INTR
48 MHz
Oscillator
Status
RX
Clock
TX
Generator
Clock
Recovery
USB Event
Detect
VReg
Circuit Description
RESET
Vcc
GND
XIN
XOUT
CLKOUT
V3.3
AGND
3-25