Lexus 2003 LS Owner's Manual page 93

If the garage door does not operate, identify if your garage
transmitter is of the "Rolling Code" type. Press and hold the
R
programmed HomeLink button. The garage door has the
rolling code feature if the indicator light (on the HomeLink
flashes rapidly and then remains lit after 2 seconds. If your
garage transmitter is the "Rolling Code" type, proceed to the
heading "Programming a rolling code system".
6. Repeat steps 2 through 5 for each remaining HomeLink
button to program another device.
Programming a rolling code system
If your device is "Rolling Code" equipped, it is necessary
to follow steps 1 through 4 under the heading
R
"Programming the HomeLink " before proceeding with
the steps listed below.
1. Locate the "training" button on the ceiling mounted garage
door opener motor. The exact location and color of the button
may vary by brand of garage door opener. Refer to the owner's
guide supplied by the garage door opener manufacturer for the
location of this "training" button.
2. Press the "training" button on the ceiling mounted garage
door opener motor.
Following this step, you have 30 seconds in which to initiate
step 3 below.
3. Press and release the vehicle's programmed HomeLink
button twice. The garage door may open. If the door does
open, the programming process is complete. If the door does
R
) not open, press and release the button a third time. This third
press and release will complete the programming process by
opening the garage door.
The ceiling mounted garage door opener motor should now
R
recognize the HomeLink
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink
program.
2. Place your hand–held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand–held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
buttons.
INTERIOR EQUIPMENT
R
unit and be able to activate the
R
buttons you want to
R
.
R
in view while
R
button.
R
changes from a
R
R
79