Lexus 2003 LS Owner's Manual page 503

Placing a Call
Phone (keypad)
Refer to the phone instruction manual.
Speed Dial (command module)
Push one of the three function keys on the command module.
A single beep indicates that the system has accepted the en-
tered input and has staged that specific memory to place the
call. Press the hook key on the command module and the tele-
phone computer will place the call. A dual beep after pressing
the hook key indicates that you entered the speed dial in error,
or that there was no memory found in the speed dial of the
phone. The speed dialing function provides a specific numbers
for you to access when placing a call. The system pulls these
numbers from the phone's speed dial memory. It is important to
understand that only those speed dial entries which correspond
to the 3 function keys will be accessed when placing a call.
This represents a total of 3 separate memory dials that are
available.
While the vehicle is in motion operate the system ONLY WHEN
SAFE to do so.
USE THIS SYSTEM ONLY IN LOCATIONS WHERE IT IS LE-
GAL TO DO SO. SOME STATES, PROVINCES, COUNTIES,
OR CITIES HAVE LAWS PROHIBITING THE USE OF CELLU-
LAR PHONES AND VIDEO SCREENS WHILE THE VEHICLE
IS IN MOTION.
If after pushing the function keys on the command module, the
hook key is pressed for more than two seconds, or if the hook
key is not pressed within two seconds, the speed dial input will
be cleared and the call will be cancelled. Pressing the function
key 1, 2 or 3 twice in succession will also cancel the call.
Section 2 Using the Lexus Integrated Mobile Phone
System in Vehicles equipped without
16
Navigation
CAUTION
NOTICE
INFORMATION