Lexus 2003 LS Owner's Manual page 632

Automatic Air Conditioning Controls
SETTING OPERATION – manual control
When one of the manual control buttons
is depressed while operating in automat-
ic mode, the mode relevant to the de-
pressed button is set. Other conditions
continue to be adjusted automatically.
If manual air flow selection is desired –
21L078
The outlets from which air is delivered can be
selected manually by touching the switch.
The function of each mode is as follows:
1 Panel – Air flows mainly from the instru-
ment panel vents.
2 Bi–level – Air flows from both the floor
vents and the instrument panel vents.
3
Floor – Air flows mainly from the floor
vents.
It is recommended that you close the lower
vent. For details about this, see page 124.
4
Floor/Windshield – Air flows mainly
from the floor vents and windshield
vents.
It is recommended that you close the lower
vent. For details about this, see page 124.
The selected mode is highlighted in green.
If quick heating or cooling is desired –
Push the "TEMP" or "PASSENGER TEMP"
button on either side and hold it until the max-
imum figure or minimum figure appears.
If manual fan speed control is desired –
" 1 Fan speed at low
2 Fan speed at high
The fan speed can be set to your desired
speed by touching the appropriate air flow
control switch. The higher the fan speed is,
the more air is delivered. Pushing the "OFF"
button turns off the fan.
To remove exterior windshield frost, use the
high speed setting.
The selected mode is highlighted in green.
117