Sennheiser PXC 310 BT Quick Manual page 26

Putting the PXC 310 BT into operation
1
5
1
2s
5
1
1
3s
1
1
2s
5
12
Pairing the headphones with an audio source
Press the Master button
flashes 3 times red. The headphones switch off (see "Switching the
headphones off" on page 16).
Press the Master button
alternately flashes blue and red.
On your audio source, activate the Bluetooth function "Add a new
device".
Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device
identification information. The
hear an ascending beep. The devices have identified each other and the
headphones are paired with the audio source.
PIN code
When the audio source prompts for a password or PIN code,
enter the default PIN code "0000".
If a connection is established, the
blue.
If no device is found within approx. 5 minutes, the
3 times red and you hear a descending beep. The headphones will then try
for 3 minutes to connect to one of the 5 known audio sources. If this fails,
the headphones automatically switch off.
In this case, repeat the necessary steps to pair the headphones with the
audio source again.
Switching the "Bluetooth connection" flashing on/off
Switch the headphones off (see "Switching the headphones off" on
page 16).
To switch the "Bluetooth connection" flashing off:
Press the Master button
alternately flashes blue and red.

6 Press the Volume
To switch the "Bluetooth connection" flashing

Press the Volume
3
and keep it pressed until the
and keep it pressed until the
Star LED flashes 3 times blue and you
Star LED continues to slowly flash
and keep it pressed until the
button for more than 3 seconds.
on again:
button for more than 3 seconds.
Star LED
Star LED
Star LED flashes
Star LED