Recommended Drive Cable Connections - Dell OptiPlex 330 User Manual

5 card connector
5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep
dust and dirt out of your computer.
6. Snap the card retention latch into place.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
7. Replace the computer cover (see
8. Reconnect the computer and devices to electrical outlets, and then turn them on.
9. Uninstall the card's driver. See the documentation that came with the card for instructions.
10. If you removed a sound card:
a. Enter system setup (see
b. Connect external audio devices to the audio connectors on the back panel of the computer.
11. If you removed a network adapter card:
a. Enter system setup, select Audio Controller, and change the setting to On (see "Entering System Setup" on page 25).
b. Connect the network cable to the integrated network connector on the back panel of the computer.
Drives
Your computer supports a combination of these devices:
One SATA (serial ATA) hard drive
l
One optional floppy drive
l
One optional optical drive
l
1 optical drive
3 floppy drive

Recommended Drive Cable Connections

Connect the serial ATA hard drive to connectors labeled "SATA0"on the system board.
l
Connect the serial ATA CD or DVD drive to connectors labeled "SATA1 ".
l
Replacing the Computer Cover).
Entering System Setup), go to Onboard Devices and select Integrated Audio, and then change the setting to On.
2 hard drive