Installing A Hard Drive - Dell OptiPlex 330 User Manual

1 hard-drive data cable 2 hard-drive data connector on system board
3 power cable
5. Remove the four screws securing the hard drive.
6. Slide the drive out away from the front of the computer.
7. If removing this drive changes the drive configuration, then be sure to reflect these changes in system setup. When you restart your computer, enter
system setup (see System Setup), then go to the "Drives" section of the system setup and under Drive 0 through 3, set the Drive to the correct
configuration.
8. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
9. Connect your computer and devices to electrical outlets and turn them on.

Installing a Hard Drive

1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Check the documentation for the drive to verify that it is configured for your computer.
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).