Drive-Panel Inserts - Dell OptiPlex 330 User Manual

1 hard-drive data 2 hard-drive data connector on system board (SATA0
cable or SATA1)
3 power cable
10. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
11. Connect your computer and devices to electrical outlets, and then turn them on.
12. See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Check the system setup for drive configuration changes (see

Drive-Panel Inserts

1. Follow the procedures in Before You
2. Remove the drive panel by sliding the drive release latch downward to open the panel. Then, remove the drive panel from the hinges.
1 drive panel
3 drive-panel insert
3. Find the drive-panel insert in front of the drive bay that you want to use.
4. Gently press the release tab of the insert to remove it from the drive panel.
Replacing the Computer Cover).
Entering System
Begin.
2 release tab
Setup).