Define The Content Of The Paper Trays - Oce VarioPrint 2090 Configuration And Maintenance Manual

Define the content of the paper trays

Introduction
Task for: key operator
Each paper tray can contain three types of paper. The paper types are shown at
the operator panel when you select a paper tray.
You can define the contents of each tray.
Normal paper (tray 3 is always used for normal paper)
■
or any combination of:
Special
■
Covers
■
The first two paper types can be assigned to an entire job (i.e. for a job to be
printed on special paper).
The paper type cover enables you to configure a paper tray for cover material.
If such a tray is configured, the system will use paper from that tray for the
covers.
When no special paper types have been assigned to a tray, the tray
Note:
contains the paper type normal. It is possible to configure more than one tray
for any of these four paper types. At least one of the trays must contain normal
paper.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the key
operator mode (see 'Access the Océ VarioPrint 2090 Settings Editor in key
operator mode' on page 9).
52 Océ VarioPrint 2090 Configuration and maintenance manual