Energy Save Settings; Set The Epa Timers - Oce VarioPrint 2090 Configuration And Maintenance Manual

Energy save settings

Set the EPA timers

Introduction
Task for: key operator
The Océ Smart Imager can request the system to go to the energy save mode.
The system can go into sleep mode.
■
The Océ Smart Imager can not go into sleep mode.
■
Low power mode time
The interval between the last print action of the system and the moment the
Océ VarioPrint 2090 turns to low power mode.
The Océ VarioPrint 2090 turns to low power mode when the 'Low power mode
timer' expires (period of no print activity). The default value of the low power
mode timer is 15 minutes. You can not manually put the Océ VarioPrint 2090
into low power mode.
If the system is in low power mode, the Océ Smart Imager activates the system
when a new automatic print job starts or you start a copy or interactive print
job. This process can take several minutes.
You can scan a job when the system is in low power mode or is warming up.
Sleep mode time
The interval between the last action of the system and the moment the Océ
VarioPrint 2090 turns to sleep mode.
When the 'Sleep mode timer' expires, the Océ VarioPrint 2090 turns into sleep
mode. You can put the Océ VarioPrint 2090 into sleep mode manually.
The default value of the sleep mode timer is 60 minutes.
You can change the factory default settings of both EPA timers to values from
1 to 240 minutes.
When to do
Change the timer settings when the factory settings cause problems to the
productivity.
24 Océ VarioPrint 2090 Configuration and maintenance manual