Planar Bay Cat X SN-4620-1080 User Manual page 105

Setting
Asset Tag
Backlight Status
Internal Temperature
Mode ID
HPer
VLines
Unit Status Settings
An optional user settable field which is set via the RS-232 port. This could be a serial num-
ber, name or any other piece of information desired
Shows OK if the electronics module detects that both banks of backlights are functioning
normally. Shows Failed if one or both of the backlight banks is not drawing the correct
amount of current
The current internal temperature at one point on the electronic module. This is not neces-
sarily the highest nor the lowest temperature point of the unit, nor is it an indicator of ambi-
ent temperatures.
If thermal guidelines (see "Normal Use Thermal Guidelines" on page 133) are exceeded
and additional ventilation or cooling has been implemented, this temperature may be used
as a datapoint to determine if the temperature of the unit is being affected
The index number of the mode from the internal mode table for the incoming signal. This is
used in diagnosis of mode detection problems.
Each mode has a number, and this is the number of the one used now. For XGA, for
instance, there are several, each with a different vertical frequency, number of active lines,
total number of lines
The measured horizontal period of the incoming signal. This is used in diagnosis of mode
detection problems
The number of horizontal lines detected per vertical period. This is used in diagnosis of
mode detection problems
Description
98