Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
The server can be turned off in any of the following ways:
v You can turn off the server from the operating system, if your operating system
v You can press the power-control button to start an orderly shutdown of the
v If the operating system stops functioning, you can press and hold the
v If the server is connected to an Advanced System Management interconnect
v If an optional Remote Supervisor Adapter II is installed in the server, the server
v If the Wake on LAN feature turned on the server, the Wake on LAN feature can
v You can turn off the server through a request from the service processor.
Removing the cover
Complete the following steps to remove the cover:
1. Read the safety information beginning on page v and "Installation guidelines" on
supports this feature. After an orderly shutdown of the operating system, the
server will be turned off automatically.
operating system and turn off the server, if your operating system supports this
feature.
power-control button for more than 4 seconds to turn off the server.
network that contains at least one server with an optional Remote Supervisor
Adapter II installed, the server can be turned off from the Remote Supervisor
Adapter II user interface.
can be turned off from the Remote Supervisor Adapter II user interface.
turn off the server.
page 7.
Chapter 2. Installing options
9