Major Components Of The Xseries 306 Type 8836 - IBM eserver xSeries 306 Option Installation Manual

Type 8836
Table of Contents

Advertisement

Major components of the xSeries 306 Type 8836

Blue on a component indicates touch points, where you can grip the component to
remove it from or install it in the server, open or close a latch, and so on.
Orange on a component or an orange label on or near a component indicates that
the component can be hot-swapped, which means that if the server and operating
system support hot-swap capability, you can remove or install the component while
the server is running. (Orange can also indicate touch points on hot-swap
components.) See the instructions for removing or installing a specific hot-swap
component for any additional procedures that you might have to perform before you
remove or install the component.
The following illustration shows the major components in the server.
SCSI hard disk
drive (some models)
Bezel
Heat sink
Fans
CD-ROM drive
Captive screw
Riser-card
assembly
Power supply
DIMM
System board
Diskette drive
Chapter 1. Introduction
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eserver xseries 306 type 8836

Table of Contents