Updating The Server Configuration - IBM eserver xSeries 306 Option Installation Manual

Rear
System power
connector

Updating the server configuration

When you start the server for the first time after you add or remove an internal
option or external SCSI device, you might receive a message that the configuration
has changed. The Configuration/Setup Utility program starts automatically so that
you can save the new configuration settings. For more information, see the section
about configuring the server in the User's Guide on the IBM xSeries Documentation
CD.
Some options have device drivers that you need to install. See the documentation
that comes with the device for information about installing any required device
drivers.
If the server has a RAID configuration using the SCSI controller with integrated
RAID (SCSI models only) or the integrated Serial ATA controller with integrated
RAID and you have installed or removed a hard disk drive, you might have to
reconfigure your disk arrays. See the RAID documentation on the IBM
ServeRAID-7e (Adaptec HostRAID) Support CD for more information about
reconfiguring the disk arrays.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For more information about configuring the integrated Gigabit Ethernet controllers,
see the User's Guide.
20
xSeries 306 Type 8836: Option Installation Guide
Keyboard Mouse
connector connector
Serial Video
connector connector
Ethernet 1 connector
Ethernet 2 connector
USB connectors