Installing Wheel Lock Shoe Extensions - Invacare 9000 SL Service Manual

Installing Wheel Lock Shoe Extensions

NOTE: For this procedure, refer to FIGURE 8.5.
1. Loosen the two (2) set screws on the wheel lock shoe extension until the set screws do
not protrude into the slot.
2. Insert the disk wheel lock shoe into the slot in the shoe extension.
NOTE: Ensure the pointed end of the wheel lock shoe extension is facing toward the rear wheel.
3. Position the wheel lock shoe extension so the outside edge is flush with the out side
edge of the wheel lock shoe.
4. Securely tighten the two (2) set screws to secure the wheel lock shoe extension to the
wheel lock shoes.
Wheel Lock Shoe Extension
Pointed End of Wheel
Lock Shoe Extension
FIGURE 8.5 Installing Wheel Lock Shoe Extensions
Part No. 1076155
SECTION 8—ANTI-TIPPERS/WHEEL LOCKS
Set Screws
Slot
85
9000 Series