Removing/Installing Rear Wheels; With Patient Operated Wheel Locks; With Attendant Operated Wheel Locks; Using/Adjusting Wheel Locks - Invacare 9000 SL Service Manual

Removing/Installing Rear Wheels

With Patient Operated Wheel
Locks
NOTE: For this procedure, refer to
FIGURE 7.12.
1. Remove the axle mounting screw and
locknut that secure the patient
operated wheel lock, spacers, and rear
wheel to the wheelchair frame.
2. Secure rear wheel, patient operated
wheel lock, and spacers to wheelchair
frame with axle mounting screw and
locknut. Torque locknut to 40‐50 ft./lbs.

With Attendant Operated Wheel Locks

NOTE: For this procedure, refer to
FIGURE 7.13.
1. Remove the axle mounting screw and
locknut that secure the rear wheel and
spacer to the wheelchair frame.
2. Remove rear wheel from side frame.
3. Secure rear wheel and spacer to
wheelchair frame with axle mounting
screw and locknut. Torque locknut to
40‐50 ft./lbs.

Using/Adjusting Wheel Locks

NOTE: For Using and/or Adjusting of Patient Operated Wheel Locks, refer to Using/Adjusting
Disk Wheel Locks on page 82.

Using Attendant Operated Wheel Locks

DO NOT attempt to stop a moving wheelchair with wheel locks. Wheel locks are
not brakes.
Part No. 1076155
Wheelchair Frame
Locknut
Spacers
Rear
Wheel
FIGURE 7.12 Removing/Installing Rear
Wheels - With Patient Operated Wheel
Axle
Wheelchair Frame
Mounting
Screw
FIGURE 7.13 Removing/Installing Rear
Wheels - With Attendant Operated Wheel
WARNING
75
SECTION 7—RECLINER
Patient Operated
Wheel Lock
Axle
Mounting
Screw
Locks
Locknut
Spacer
Rear
Wheel
Locks
9000 Series