Cisco Aironet 1100 Series Installation And Configuration Manual page 312

Table H-1 Error and Event Messages (continued)
Message
DOT11-4-CANT_ASSOC: Cannot
associate: [chars]
Inter-Access Point Protocol Messages
DOT11-6-ROAMED: Station
[mac-address] Roamed to [mac-address]
DOT11-6-STANDBY_ACTIVE:
Standby to Active, Reason = [chars]
([int])
DOT11-6-ROGUE_AP: Rogue AP
[mac-address] reported. Reason: [chars]
SCHED-3-UNEXPECTEDMESSAGE:
Unknown message [hex] received (ptr
arg [hex], num arg [hex]).
SCHED-3-UNEXPECTEDEVENT:
Process received unknown event (maj
[hex], min [hex]).
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
H-4
Explanation
The unit could not establish a connection
to a parent asccess point for the displayed
reason.
A station has roamed to a new access
point.
The access point is transitioning from
standby mode to active mode.
A station has reported a potential rogue
access point for the stated reason.
A process can register to be notified when
various events occur in the router. This
message indicates that a process received
a message from another process that it
does not know how to handle.
A process can register to be notified when
various events occur in the router. This
message indicates that a process received
an event that it did not know how to
handle.
Appendix H Error and Event Messages
Recommended Action
Check the configuration of both the
parent access point and this unit to
make sure the basic settings (SSID,
WEP, and others) match.
None.
None.
None.
Copy the error message exactly as it
appears, and report it to your technical
support representative.
Copy the error message exactly as it
appears, and report it to your technical
support representative.
OL-2851-01