Cisco Aironet 1100 Series Installation And Configuration Manual page 192

Configuring Filters Using the Web-Browser Interface
Select Forward All or Block All from the Default Action menu. The filter's default action must be the
Step 8
opposite of the action for at least one of the Ethertypes in the filter. For example, if you enter several
Ethertypes and you select Block as the action for all of them, you must choose Forward All as the filter's
default action.
Click Apply. The filter is saved on the access point, but it is not enabled until you apply it on the Apply
Step 9
Filters page.
Click the Apply Filters tab to return to the Apply Filters page.
Step 10
Figure 15-6 Apply Filters Page
Step 11 Select the filter number from one of the Ethertype drop-down menus. You can apply the filter to either
or both the Ethernet and radio ports, and to either or both incoming and outgoing packets.
Step 12 Click Apply. The filter is enabled on the selected ports.
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
15-10
Chapter 15 Configuring Filters
Figure 15-6 shows the Apply Filters page.
OL-2851-01