Maximum Power Levels - Cisco Aironet 1100 Series Installation And Configuration Manual

Appendix C Channels and Antenna Settings

Maximum Power Levels

An improper power level setting can result in equivalent isotropic radiated power (EIRP) above the
amount allowed per regulatory domain.
allowed for each regulatory domain. For additional information, refer to
Power" section on page
Table C-2
Regulatory Domain
Americas (-A)
(4 watts EIRP maximum)
EMEA (-E)
(100 mW EIRP maximum)
Japan (-J)
(10 mW/MHz EIRP maximum)
Israel (-I)
(100 mW EIRP maximum)
France is included in the ETSI regulatory domain; however, channels 1 through 9 can be used with up
Note
to 10mW EIRP and channels 10 through 13 can be used with up to 100mW EIRP. Users are responsible
for ensuring that the channel set configuration is in compliance with the regulatory standards of France.
Mexico is included in the Americas regulatory domain; however, channels 1 through 8 are for indoor use
Note
only while channels 9 through 13 can be used indoors and outdoors with up to 650mW EIRP. Users are
responsible for ensuring that the channel set configuration is in compliance with the regulatory standards
of Mexico.
OL-2851-01
7-5.
Maximum Power Levels
Antenna Gain (dBi)
2.2
2.2
2.2
2.2
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
Table C-2 indicates the access point's maximum power level
Maximum Power Level (mW)
100
50
30
50
Maximum Power Levels
"Configuring Radio Transmit
C-3