Cisco Aironet 1100 Series Installation And Configuration Manual page 311

Appendix H Error and Event Messages
Table H-1 Error and Event Messages (continued)
Message
PMIP-6-STOP: Proxy Mobile IP
services have stopped
PMIP-6-REPEATER_STOP: AP is now
operating as a repeater, disabling Proxy
Mobile IP services
Unzip Messages
SOAP-4-UNZIP_OVERFLOW: Failed
to unzip
flash:/c1100-k9w7-mx.122-3.6.JA1/ht
ml/level15/ap_xxx.htm.gz, exceeds
maximum uncompressed html size
802.11 Subsystem Messages
DOT11-6-FREQ_INUSE: Radio
frequency [int] is in use
DOT11-6-FREQ_USED: Radio
frequency [int] selected
DOT11-4-VERSION_MISMATCH:
Require radio version [hex].[int], found
version [hex].[int]
DOT11-2-VERSION_INVALID:
Unable to find required radio version
[hex].[int]
DOT11-4-NO_SSID: No SSIDs
configured, radio not started
DOT11-4-FLASHING_RADIO:
Flashing the radio firmware ([chars])
DOT11-2-NO_FIRMWARE: No radio
firmware file ([chars]) was found
DOT11-2-BAD_FIRMWARE: Radio
firmware file ([chars]) is invalid
DOT11-4-FLASH_RADIO_DONE:
Flashing the radio firmware completed
DOT11-4-LINK_DOWN: Radio parent
lost: [chars]
OL-2851-01
Explanation
Proxy Mobile IP service has stopped.
Proxy Mobile IP does not run on
repeaters or workgroup bridges, and it is
disabled automatically when the access
point is in repeater mode.
The HTTP server cannot retrieve a
compressed file in response to an HTTP
GET request because the size of the file is
too large for the buffers used in the
uncompression process.
When scanning for an unused frequency,
the unit recognized another radio using
the displayed frequency.
After scanning for an unused frequency,
the unit selected the displayed frequency.
When starting the radio, the wrong
firmware version was found. The radio
will be loaded with the required version.
When trying to reflash the radio
firmware, the access point recognized
that the radio firmware packaged with the
IOS firmware had the incorrect version.
All SSIDs were deleted from the
configuration. At least one must be
configured for the radio to run.
The radio has been stopped to load new
firmware.
When trying to flash new firmware into
the radio, the file for the radio was not
found in the flash file system.
When trying to flash new firmware into
the radio, the file was found to be invalid.
The radio firmware flash is comeplete,
and the radio will be restarted with the
new firmware.
The connection to the parent access point
was lost for the displayed reason. The
unit will try to find a new parent access
point.
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
Recommended Action
None.
None.
Make sure file is a valid HTML page. If
so, you'll have to copy an
uncompressed version of the file into
flash to retrieve it through HTTP.
None.
None.
None.
None.
Configure at least one SSID on the
access point.
None.
The wrong image has been loaded into
the unit. Locate the correct image based
on the type of radio used.
Put the correct firmware image file in
the place where the unit is looking.
None.
None.
H-3