Table of Contents
Advertisement
3
Getting Started
A. Design and Installation Considerations
These appliances must be installed outdoors.
This outdoor gas appliance is designed for outdoor use. It
may also be installed in screened porches and lanais that
meet these minimum requirements:
• Minimum porch area: 96 sq. ft.
• Minimum ceiling height 84 in.
• Minimum of two walls must be screened.
• Minimum top of screen height, side walls: 6 ft. 8 in.
• Minimum screen area: 64 sq. ft.
Refer to Section 4.B. for clearances.
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional,
state and national codes and regulations.
• Consult insurance carrier, local building, fire
officials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
When planning an appliance installation, it's necessary to
determine the following information before installing:
• Where the appliance is to be installed.
• Gas supply piping.
• Electrical wiring.
• Framing and finishing details.
Moisture Resistance
This outdoor gas appliance will shed moderate amounts
of water, but is not waterproof. Water and condensing
water vapor may enter the enclosure under certain condi-
tions.
The appliance will not perform as an exterior wall. Mois-
ture penetration must be considered for construction that
places the appliance in structure walls or on moisture
sensitive surfaces.
When installed on exterior walls: Hearth & Home
Technologies recommends that the appliance enclosure
be constructed outside the structure's weather envelope.
Where the platform meets the wall, use a flashing detail
similar to that required for attached decks. Enclosure
platforms, including hearths should slope away from the
8
Outdoor Lifestyles • Villa Gas Owners/Installation Manual • 4072-170 • Rev C • 04/01/14
structure at 1/8 in. to 1/4 in. per foot. The appliance can
be shimmed level.
When installed on surfaces where water may collect
or cause damage: Hearth & Home Technologies recom-
mends that a drainage pan be placed under the unit. This
can be constructed of metal, adhesive polymer mem-
brane (such as ice and water shield) or other suitable
materials. A means of drainage out of the pan such as
tubes or weep holes should be provided. A slope of 1/8 in.
to 1/4 in. per foot towards the drain port is suggested. The
appliance can be shimmed level.
Hearths should slope away from the front of the appliance
and enclosure at 1/8 in. to 1/4 in. per foot.
B. Inspect Appliance and Components
• Remove the appliance and components from the
packaging and inspect for damage.
• Report any parts damaged in shipment to your dealer.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
WARNING! Risk of Fire or Explosion!
could impair safe operation. DO NOT install damaged, in-
complete or substitute components. Keep alliance dry.
Hearth & Home Technologies disclaims any responsibil-
ity for, and the warranty will be voided by, the following
actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire or Explosion! DO NOT use this
appliance if any part has been under water. Call a qualified
service technician to inspect the appliance and to replace
any part of the gas control system which has been under
water.
Damaged parts
Hide quick links:
Advertisement
Table of Contents
