Table of Contents
Advertisement
D. Securing and Leveling the Appliance
WARNING! Risk of Fire!
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the enclosure to prevent entry of
blown-in insulation. Make sure insulation and other ma-
terials are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause over-
heating and fire.
The diagram shows how to properly position and secure
the appliance (see Figure 4.4). Nailing tabs are provided to
secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs flush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the floor by inserting two screws
through the pilot holes at the bottom of the appliance.
NAILING TABS
(BOTH SIDES)
Figure 4.4
Proper Positioning and Securing of an Appliance
12
Outdoor Lifestyles • Villa Gas Owners/Installation Manual • 4072-170 • Rev C • 04/01/14
Prevent contact with:
E. Non-Combustible Material Installation
Combustible
Framing
Figure 4.5
Noncombustible Material Installation
• A 12 in. noncombustible facing material (supplied) is
required off the top of the appliance. Above 12 in., a
combustible facing material is acceptable.
• Combustible framing can be installed above appliance
top standoffs, behind the 12 in. noncombustible facing.
Combustible
Facing
12 in.
Noncombustible
Facing
Hide quick links:
Advertisement
Table of Contents
