Table of Contents
Advertisement
2
Getting Started
A. Design and Installation Considerations
The Courtyard series gas appliance is designed for
outdoor use and may be installed as a stand alone unit
or built into a wall.
An outdoor space is defined as follows:
•
An appliance is considered to be outdoors if
installed with shelter no more inclusive than:
1. With walls on all sides, but no overhead cover
2. Within a partial enclosure which includes an
overhead cover and no more than two side walls.
These side walls may be parallel, as in a breezeway,
or at right angles to each other; or
3. Within a partial enclosure which includes an
overhead cover and three sidewalls, as long
as 30% or more of the horizontal peripery of the
enclosure is permanently open.
The appliance may be installed on a wood or non-
combustible deck. Refer to section three for clearances.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult the authorities
having jurisdiction over restrictions, installation
inspection and permits.
Before installing, determine the following:
•
Where the appliance is to be installed.
– Clearances to side walls.
– Location of indoor appliance terminations, air
inlets, gas meters, etc.
– Location of the fireplace to a door that swings
open to ensure it doesn't interfere with the
fireplace when opened
– Location of Windows.
– Location of Walkways.
– Possibility of flooding or running water.
•
Gas supply piping requirements.
•
Electrical wiring requirements.
•
Framing and finishing details.
•
Prevailing wind
B. Tools and Supplies Needed
Before beginning the installation be sure that the
following tools and building supplies are available.
Tape Measure
Pliers
Phillips screwdriver
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Courtyard Installation Manual • 4608-901 Rev. A • 02/18
Framing material
Hammer
Manometer
Gloves
Voltmeter
Plumb line
Level
3/4 inch wrench
7/8 inch wrench
7/16 inch wrench
Flat head screwdriver
Non-corrosive leak check solution
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
Caulking material (300°F Minimum continuous
exposure rating.)
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
Framing square
Electric drill and bits (1/4 inch)
Safety glasses
Reciprocating saw
Crescent wrench
1/4 inch nut driver
Pipe sealant
5
Hide quick links:
Advertisement
Table of Contents
