Getting the Tag Type
Use this option to determine the type of HF tag loaded into the printer.
"Get the Tag Type" whenever you load supplies or open and close the
printhead.
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1.
Press ! or " until you see
RFID SETUP
Get Tag Type
Load supplies with the tag's antenna over the printer's 5-coil antenna.
2.
(The coil antenna is located behind the platen roller.)
3.
Press Enter/Pause. The tag type appears on the display.
TI ISO15693
Blks: 8
If the tag cannot be found, "No Tag Found" appears briefly on the
display. Try moving the tag slightly forward or backward in the
supply path over the coil antenna and try again.
4.
Press Enter/Pause.
Save Protocol
!
Yes
5.
Select "Yes" or "No" to save the protocol and press Enter/Pause.
If you select "Yes," the setting is saved and displayed when you
select Protocol from the Menu.
Note:
If the Protocol is set to AUTO Select, the printer automatically
detects the type of HF tag loaded.
6.
Press Escape/Clear until you see the Main Menu.
"
Byts: 4
Multi-Protocol Encoding 2-3