Cleaning The Scanner Window And Terminal Screen - Intermec Trakker Antares 243X User Manual

Cleaning the Scanner Window and Terminal Screen

Trakker Antares 243X Handheld Terminal User's Manual
39
nugget
Chapter 4— Troubleshooting and Maintaining the Terminal
To perform a cold boot
1 If possible, press f or ' to turn off the terminal.
2 Press and hold the f key or the ' key for approximately 12 seconds.
The Good Read LED blinks once and the terminal turns off.
3 Press f or ' to turn on the terminal. The Boot Menu appears.
4 Press 1 to boot the terminal. Once the terminal has finished booting,
your application appears.
5 Set the time and date. For help using the TRAKKER Antares 2400
Menu System, see "Configuring the Terminal With the Menu System"
on page 35.
There are no user-serviceable parts inside the terminal. Opening the
unit will void the warranty and may cause damage to the internal
components.
Attention: La terminal ne contient pas de pièces révisibles par
l'utilisateur. Le fait d'ouvrir l'unité annule la garantie et peut
endommager les pièces internes.
The terminals are built for use in an industrial working environment. You
may need to perform these minor maintenance tasks to keep the terminal
in good working order:
• Clean the scanner window.
• Clean the terminal screen.
Clean the scanner window and terminal screen as often as needed for the
environment in which you are using the terminal.
To clean the scanner window and terminal screen
1 Press f or ' to turn off the terminal.
2 Use a solution of mild soap and water.
3 Dip a clean towel or rag in the soap and water solution and wring out
the excess solution. Wipe off the scanner window and terminal screen.
Do not allow any abrasive material to touch these surfaces.
4 Wipe dry.
81