What's New; Using The Terminal For The First Time - Intermec Trakker Antares 243X User Manual

What's New?

Using the Terminal for the First Time

Trakker Antares 243X Handheld Terminal User's Manual
39 AGaramond
nugget
With this user's manual revision, the following changes were made to
support software on Trakker Antares 243X terminals with firmware
version 8.01:
• Software was added to the Trakker Antares terminals to support the
Wavelink Avalanche client management system. For more information,
see Chapter 2, "Configuring and Managing the Terminals," in the 2400
Family System manual.
• Information from the Trakker Antares 2400 Family System Manual
Addendum was incorporated: 802.1X security enhancements to provide
new functionality to the current TTLS security and support for Cisco's
LEAP security. For more information, see "Configuring the 802.1x
Security Parameters" on page 58.
Before you can use the 243X for the first time, you need to perform certain
steps, such as charging and installing the battery pack. You can find this
information throughout this user's manual. However, if you want to start
using the terminal immediately, see the Trakker Antares 243X Handheld
Terminal Quick Start Guide (P/N 071792).
To use the 243X for the first time
1 Unpack the terminal and documentation. For help, see "Unpacking the
Terminal" on page 7.
2 Charge and install the battery pack (sold separately). For more
information about batteries, see "Using the Terminal's Battery Pack" on
page 8.
3 Press f or ' to turn on the terminal. For more information about
the keypad, see "Using the Keypad" on page 12.
4 Set the time and date. For help using the TRAKKER Antares 2400
Menu System, see "Configuring the Terminal With the Menu System"
on page 35.
5 Configure the serial port parameters. For more information, see "Using
Serial Communications on the Terminal" on page 51.
6 (2435 only) Configure the RF parameters. For more information, see
"Using RF Communications on the 2435" on page 54.
7 (2435 with 802.1x security only) Configure the 802.1x TTLS or LEAP
security parameters. For help, see "Configuring the 802.1x Security
Parameters" on page 58.
Chapter 1— Learning About the Terminal
3