Managing Battery Power - Intermec Trakker Antares 243X User Manual

Managing Battery Power

Trakker Antares 243X Handheld Terminal User's Manual
39 AGaramond
nugget
5 Insert the top edge of the battery door into the top of the battery
compartment. Push the door down to close it over the battery
compartment.
6 Push the battery door latch up and slide it toward the top end of the
243X to lock the door in place.
7 Attach the handstrap by inserting the handstrap hook as shown and
rotating the handstrap hook 90 degrees toward the top of the terminal.
Note: The handstrap is most effective if it crosses the entire back of the
hand and not just the fingers.
To maximize the life of the battery pack, use these power management
features.
Managing Battery Power
Situation
You are operating
the terminal and the
Battery status icon
turns on.
Chapter 1— Learning About the Terminal
243XU005.eps
Handstrap
hook
Ways to Save Battery Power
Press f or ' to turn off the terminal. Remove the battery
pack and insert another fully charged battery pack. You must
insert another fully charged battery pack within 15 minutes of
removing the old battery pack or you may lose data.
Or, if you want to continue using the terminal and you do not
have another battery pack, insert the terminal into the powered
vehicle dock. The vehicle dock must be connected to an AC
power supply.
243XU002.eps
11