KYMCO People GT 200i Service Manual page 208

18. STARTING SYSTEM
INSTALLATION
Connect the starter motor cable.
Check the O-ring for wear or damage and
replace if necessary.
Apply grease to the O-ring and install it to the
starter motor.
Tighten the two mounting bolts.
STARTER RELAY INSPECTION
Disconnect the starter relay wire connector.
Check for continuity between the yellow/red
wire and green/yellow wire.
There should be continuity when the starter
button is depressed.
If there is no continuity, check the starter
button for continuity and inspect the wire.
OPERATION TEST
Connect the electric meter to the starter relay
terminals that connect to the battery positive
cable and the starter motor cable.
Connect a fully charged battery across the
starter relay yellow/red and green/yellow wire
terminals.
Check for continuity between the starter relay
large terminals. The relay is normal if there is
continuity and hear sounds.
People GT 200i
Starter Motor Cable
O-ring
Yellow/Red Wire And Green/Yellow
Wire
Starter Relay test chart
18-4