JVC HM-DT100U Instructions Manual page 88

88
EN
PLAYBACK
SYMPTOM
9. Sound cannot be heard.
RECORDING
SYMPTOM
1. Recording will not start.
2. TV broadcasts will not be
recorded properly.
3. Tape-to-tape editing will not
work.
TIMER RECORDING
SYMPTOM
1. Timer recording will not work.
2. Timer programming will not
work.
POSSIBLE CAUSE
• When a HDMI to DVI conversion
cable is connected between the
VCR and TV, you need to connect
the audio cable as well to receive
sound output.
• A HDMI to HDMI connection has
been made, but the HDMI digital
sound function at the TV side may
support only 2ch-PCM.
• Your TV is unable to decode Dolby
Digital or DTS bitstream, thus there
is no sound output.
POSSIBLE CAUSE
• There is no cassette loaded.
• The loaded cassette has had its
record safety tab removed.
• The VCR has been set to "L-1", "L-
2", "F-1" or "I-1" etc. input location
by mistake.
• The components have been
incorrectly connected, or correct
video connector ([S VIDEO],
[VIDEO] or DV) is not selected.
• The power to one or more of the
units has not been turned on.
• The recording VCR's input location
has been set incorrectly.
POSSIBLE CAUSE
• The clock and/or the timer have
been set incorrectly.
• The timer is not engaged.
• The VCR has not been set up
properly.
• Timer recording is in progress.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Connect an audio cable between the
VCR and TV.
Make use of the analog audio input
connector coupled with the HDMI
video input at the TV side to connect
to the VCR's audio output.
Make use of the analog audio input
connector coupled with the HDMI
video input at the TV side to connect
to the VCR's audio output.
CORRECTIVE ACTION
Insert a cassette.
Remove the cassette and cover the
hole with adhesive tape, or load a
cassette on which the record safety
tab is intact.
Select the appropriate channel on the
VCR.
Connect the components correctly
(A pages 80, 82) or check "REAR
AUX L-1" (or "L-2") and "FRONT
AUX F-1" setting (A pages 67, 68).
Make sure the power to all units is
on.
Select the appropriate input location
on the recording VCR.
CORRECTIVE ACTION
Set the clock and/or timer correctly.
Press [TIMER (j)] and check to make
sure that [j] appears on the front
display panel.
Re-perform the set-up procedures.
Make sure you have compensated for
guide channel and VCR or cable box
channel number mismatches (A
page 42).
Timer programming cannot be
performed when timer recording is in
progress. Wait until it finishes.