Basic Playback Features; Checking Tape Position; Playing Back Tape Repeatedly - JVC HM-DT100U Instructions Manual

Basic Playback
Features
•
Turn on the VCR and the TV, and select the AV
mode on the TV.
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
IN F–1
E C
VCR
CABLE
TV
/DBS
[C.RESET]
[REW (O )]
[S]
A
The tape position indicator
appears on the screen in the
following cases:
•
•
The position of "Z" in relation to "B" (Beginning) or "E"
(End) shows you where you are on the tape.
E
NOTES:
•
•
To reset the time counter, press [C. RESET] on the
Remote. The counter reading becomes "0:00:00". It is
also reset when a tape is inserted.
[PLAY I)]
B
You can play back a tape repeatedly (50 times).
[POWER]
While playing back a tape, press and hold [PLAY (I)] for
more than 5 seconds.
The play indicator [E] on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
[TIMER ( )]
To stop playback, press [STOP (L)] on the Remote or on
C the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 mode.
G
B E G
[FF (N)]
[STOP (L )]
[T]
D

Checking tape position

When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
When you perform an
Index Search (A page 31).
"SUPERIMPOSE" must be set to "ON", or the indicator will
A
not appear ( page 68).
It may take a few seconds for the tape position indicator to be
displayed.

Playing back tape repeatedly

— Repeat Playback
29
EN
B E