HP xw8400 Workstation Hardware Setup Manual page 37

Hide thumbs Also See for xw8400 Workstation:

Table of Contents

The output is similar to the following:

Versions:

Hardware = <Hardware Version>

Micro = <Firmware version>

Genlock = 3.21

DVI = 4.01

FrameBuffer = 4.05

SDI = 4.10

Where <Hardware Version> is the current version of the DVI-Ramp hardware, and

<Firmware version> is the firmware currently loaded in the DVI ramp. If the

firmware version does not match the hardware version listed in the table that precedes this

procedure, you must perform the firmware update procedure.

To update the DVI-Ramp I firmware and software drivers:

Go to the DVI_firmwareUpdate directory by typing:

cd /mnt/cdrom/Utils/DVI_firmwareUpdate

Launch the DVI-Ramp upgrade utility by typing:

./updateDVI

The script checks the hardware version of the DVI-Ramp and then installs the firmware

update. The update should take between 5 and 10 minutes. You can monitor the progress of

the firmware update in the terminal.

The DVI-Ramp is rebooted several times during the firmware update. Any monitors

connected directly to the DVI-Ramp (such as the graphics monitor and/or a broadcast

monitor) will flash each time the DVI-Ramp is rebooted. This is normal and indicates that

the firmware is being updated.

Once the firmware update is complete, updated hardware information for your DVI-Ramp

appears in the terminal.

If you had to remove the USB-to-Serial adapter, reconnect the serial cable to the adapter,

then put the adapter back in the USB port. Restart the HP workstation.

Miranda DVI-Ramp Firmware Update

Table of Contents