HP xw8400 Workstation Hardware Setup Manual page 10

1
Introduction
a good idea to read through all chapters to familiarize yourself with the configuration
procedures for the following reasons:
•
Many suspected problems with your system may be due to loosened connections or
improperly configured devices. This guide helps you troubleshoot problems by providing
information about properly configured systems.
•
If you need to call Customer Support, familiarity with this guide puts you in a better position
to provide diagnostic information.
•
If you want to move your system at any time, or upgrade certain hardware components,
information in this guide is crucial.
Although this guide, in conjunction with the Autodesk Stone Direct 2008 Configuration Guide,
provides complete information regarding configuring hardware components, hardware
configuration should only be performed by an experienced hardware integrator familiar with
the Linux operating system, HP workstations, and peripherals associated with professional
high-performance video and post production of film.
Your Autodesk system consists of high-performance hardware that must be configured in an
environment suited to its operational needs. Other considerations include minimizing the risk
of damage due to static discharge and ensuring all components are properly grounded.
Verifying and Updating System BIOS Version
System configuration is done prior to delivery by an authorized technician, and some of the
procedures in this guide may not be necessary. BIOS settings for the workstation are provided
here for informational purposes.
The system BIOS on your workstation must correspond to the certified version required by
your Effects or Editing application version. If the BIOS version on your system does not
correspond to the table below, you must update to the certified version.
Autodesk Effect or Editing Product Version Certified BIOS Version
2007
2007 SP3 (Extension 1)
2008 SP1
To determine the CPU stepping:
1. Reboot your workstation.
Immediately after the machine reboots, while the HP start-up screen is displayed, press F10
2.
to enter Setup.
4
1.15
2.13
•
2.13, for CPUs with
stepping 6F6
•
2.26, for CPUs with
stepping 6FB